Übersicht

ESX®-IOXp

Hauptkategorie: Produkte
Information - english
ESX-IOXp Datasheet (english)
Information - german
ESX-IOXp Datasheet (german)

esx-ioxp_logoesx-ioxp

Short Description

The ESX®-IOXp electronic control unit for mobile applications is the second member of the low-cost control product family. The ESX®-IOXp is a fully-fledged freely programmable control unit with 2 independent CAN interfaces and an additional RS232 interface. Programming takes place in the widely accepted CoDeSys development environment from 3S-Smart Software Solutions in accordance with the international programming standard IEC 61131-3. This makes possible an easy and efficient familiarization and exceedingly simple and fast realization of control functions.

The ESX®-IOXp control unit offers a large number of inputs and outputs inexpensively, and is protected against over-voltage and reversed polarity.


Technical Data

Processor System  
Processor Infineo XC2287, 16 bit, fCPU= 80 MHz, system supervisor with Watchdog
SRAM 1 MByte
Flash 768 kByte
EEPROM 8 kByte

Interfaces
 
CAN 2 x CAN, 2.0B (11 bit and 29 bit identifier), Low-/High-Speed up to 1 Mbit/s
RS232 programmable baud rate (max. 115200 baud)

In-/ Outputs (max. 28)
 
Digital inputs max. 24 digital inputs, hight-/low-active (software configurable), threshold level free configurable, short-circuit protected
RPM inputs max. 6 RPM inputs,cut-off-frequency kHz, threshold level free configurable, short circuit protected
Analog inputs max. 6 analog inputs, 0 ... 10 V, 10 bit, short circuit protected
max. 8 analog inputs, 4 ... 20 mA, 10 bit, short circuit protected
PWM outputs with current measurement max. 4 x 3 A, high side switch, 0 ... 100 %, short circuit protected, diagnosable
Digital/PWM outputs optional 4 x 4 A, additional low side switch, applicable as a motor bridge, short-circuit protected, diagnosable
Digital/PWM outputs with current readback or PVG outputs optional 4 x 8 A or 8 x 4 A, high side switch, short-circuit protected, diagnosable
optional 4 x PVG outputs used for Danfoss valves (20 % UB ... 80 % UB)
Stabilized voltage output 5 V or 10 V (max. load current 100 mA), stabilized supply voltage, short circuit protected

System Data
 
Voltage supply 9 ... 32 V DC
Current requirements approx. 100 mA without external load, stand-by < 1.5 mA, total current max. 11 A

Mechanical Data
 
Connector 42 pin automotive type (Tyco/AMP)
Chassic IP 67 and IP 69k
Weight approx. 0.3 kg (0.67 lbs)
Size approx. 134 mm x 117 mm x 36 mm (5.28" x 4.61" x 1.42")

Environmental Requirements
 
Standards according to automotive, agricultural and construction indystry standards, CE-conformity
Operating tempertature -40 °C ... +80 °C (-40 °F ... +176 °F) (chassic temperature)


Block Diagram

blockdiagram_esx-ioxp


Copyright © 1985-2013, Wiedemann Gruppe top

Facebook